Aluminium Slab Props

Product Detail

Size:

Lengths, weights and maximum load capacities

MP 120 (0.80 – 1.20 m) 10.10 kg; 102 kN

MP 250 (1.45 – 2.50 m) 15.40 kg; 99.3 kN

MP 350 (1.95 – 3.50 m) 19.40 kg: 96 kN

MP 480 (2.60 – 4.80 m) 24.80 kg: 94 kN

MP 625 (4.30 – 6.25 m) 34.60 kg: 57.9 kN




Material:

Aluminium Alloy




Overview:


MULTIPROP slab props are used as individual props and – in combination with MULTIPROP frames – as shoring towers or load towers under tables. Compared with tubular steel slab props, the aluminium MULTIPROP carries significantly higher loads (up to 100 kN) whilst, at the same time, has a very low dead weight. With different frame lengths, square or rectangular shoring towers can be optimally adapted to suit individual construction site conditions. The frames also serve as platform beams and side protection for working levels.




Technical Details:

Aluminium slab props – low weight with high load capacity

MULTIPROP slab props are made of aluminium which means they are very light, e.g. the MP 350 weighs only 19.40 kg. With its extension lengths from 1.95 – 3.50 m 90% of standard operations in building construction can be covered. Ingeniously designed details ensure a long service life.




The cleverly-designed profile made of aluminium alloy absorbs impacts elastically, e.g. when a prop falls over. Material selection and design are perfectly matched. The MULTIPROP thread is self-cleaning and the free-running collar does not jam, even when dirty.




Further technical details

Built-in measuring tape

Continuous, self-cleaning, quadruple thread

Nut with 4 robust lowering cams

Possibility of using tie rod

Outer tube ECC powder coated

Profile is solid and elastic = very robust

Anti-pinch safety device integrated in the system

Wide range of accessories: Prop connector; frame MRK; tilting forkhead MKK and tilting base MKF


System:

Efficient underneath tables or as shoring tower

Connected with MRK frames, the MULTIPROP slab props are used under tables or as shoring towers. Leg loads of up to 100 kN allow cost effective transfer of loads. The MULTIPROP frames facilitate optimal customization on the construction site (regardless whether a square or rectangular assembly grid). The MULTIPROP frame can be used as a platform beam and side protection when assembling a working scaffold.

The MULTIPROP profile allows quick and easy assembly with the frames. The same frame can be connected to either the outer or the inner tube without changing the prop spacing (system spacing). The wedge is just hammered home into the frame’s coupling. Special tools are not required. Towers can be pre-assembled flat on the ground